|
|
computer upgrades, memory upgrades, computer memory upgrade, computer upgrade, computer memory upgrades, sony memory stick, sony memory, sony memory stick 128mb, macintosh memory upgrade, powerbook memory, packard bell memory, packard bell memory upgrade, samsung memory, aptiva memory upgrade, 4 all memory, 4allmemory.com, acer memory, all 4 memory, buy memory upgrades online, cheap memory upgrade, cheap memory upgrades, dell memory upgrade, dell memory upgrades, hewlett packard memory upgrade, ibm memory upgrade, low cost memory upgrades, mac memory upgrade, packard bell memory upgrades, pc memory upgrade, presario memory, quality memory upgrades, sony memory cards What is the difference between 2-clock and 4-clock memory? Two types of SDRAM modules are the 2-clock and the 4-clock module. Structurally, they are the same, but they are accessed differently. A 2-clock SDRAM module is set up so that each clock cycle accesses two chips on the module. A 4-clock SDRAM setup accesses 4 chips per clock cycle. To choose what kind to get, you must look into the motherboard''s documentation. 4-clock modules are the more commonly used. memory The typical indication of the wrong upgrade type being used is a system memory giving error beeps and not booting as it cannot use the memory installed. The system will not proceed past POST (Power On Self Test). 2-clock was only used in 66 MHz systems. All PC 100 and PC upgrade 133 memory is 4-clock only. Do all of your SDRAM modules use SPD? SPD, or Serial Presence Detect, is a program in an EEPROM chip on the modules of SDRAM (Synchronous Dynamic Random Access Memory). It tells the system’s BIOS what the specifications and settings of the memory module are. All of our SDRAM DIMMs have SPD programming. The system BIOS should therefore memory be set on AutoDetection for memory. What is the difference between 2-clock and 4-clock memory? Two types of SDRAM modules are the 2-clock and the 4-clock module. Structurally, they are the same, but they are accessed differently. A 2-clock SDRAM module is set up so that each clock cycle accesses two chips on the module. A 4-clock SDRAM setup accesses 4 chips per clock cycle. To choose what kind to get, you must look into the motherboard''s documentation. 4-clock modules are the more commonly used. memory The typical indication of the wrong upgrade type being used is a system memory giving error beeps and not booting as it cannot use the memory installed. The system will not proceed past POST (Power On Self Test). 2-clock was only used in 66 MHz systems. All PC 100 and PC upgrade 133 memory is 4-clock only. Do all of your SDRAM modules use SPD? SPD, or Serial Presence Detect, is a program in an EEPROM chip on the modules of SDRAM (Synchronous Dynamic Random Access Memory). It tells the system’s BIOS what the specifications and settings of the memory module are. All of our SDRAM DIMMs have SPD programming. The system BIOS should therefore memory be set on AutoDetection for memory.
|