|
|
memory upgrade, memory upgrades, computer memory upgrade, computer memory upgrades, sony memory, sony memory stick 128mb, macintosh memory upgrade, powerbook memory, packard bell memory, packard bell memory upgrade, samsung memory, aptiva memory upgrade, 4 all memory, sony memory stick 256, 4allmemory.com, acer memory, all 4 memory, buy memory upgrades online, cheap memory upgrade, cheap memory upgrades, dell memory upgrade, dell memory upgrades, hewlett packard memory upgrade, ibm memory upgrade, low cost memory upgrades, mac memory upgrade, packard bell memory upgrades, pc memory upgrade, presario memory, quality memory upgrades, sony memory cards What memory is the difference between 2-clock and 4-clock memory? Two types of SDRAM modules are stick the 2-clock and the 4-clock module. Structurally, they are the same, but they are accessed differently. A 2-clock SDRAM module is set up so that each clock cycle accesses two chips sony on the module. A 4-clock SDRAM setup accesses 4 chips per clock cycle. To choose what kind to get, you must look into the motherboard''s memory documentation. 4-clock modules are the more commonly used. The typical indication of the wrong type being used is a system giving error beeps and not booting as it cannot use the memory installed. The system will not proceed past POST (Power On Self Test). 2-clock was only used in 66 MHz systems. All PC 100 and PC 133 memory is 4-clock only. Do all of your SDRAM modules stick use SPD? SPD, or Serial Presence Detect, is a program in an EEPROM chip on the modules of SDRAM (Synchronous Dynamic Random Access Memory). It tells the system’s BIOS what the specifications and settings of the memory module are. All of our SDRAM DIMMs have SPD programming. The system BIOS should therefore be set on AutoDetection for memory. What memory is the difference between 2-clock and 4-clock memory? Two types of SDRAM modules are stick the 2-clock and the 4-clock module. Structurally, they are the same, but they are accessed differently. A 2-clock SDRAM module is set up so that each clock cycle accesses two chips sony on the module. A 4-clock SDRAM setup accesses 4 chips per clock cycle. To choose what kind to get, you must look into the motherboard''s memory documentation. 4-clock modules are the more commonly used. The typical indication of the wrong type being used is a system giving error beeps and not booting as it cannot use the memory installed. The system will not proceed past POST (Power On Self Test). 2-clock was only used in 66 MHz systems. All PC 100 and PC 133 memory is 4-clock only. Do all of your SDRAM modules stick use SPD? SPD, or Serial Presence Detect, is a program in an EEPROM chip on the modules of SDRAM (Synchronous Dynamic Random Access Memory). It tells the system’s BIOS what the specifications and settings of the memory module are. All of our SDRAM DIMMs have SPD programming. The system BIOS should therefore be set on AutoDetection for memory.
|